Location:新闻中心 > 行业动态 > The article body

行业动态

Industry news

  • Double-sided single-sided tin plate tin bad how to deal with
  • Release time : 2015-03-27 Click on the number of times: 5111 
  • Tin leveled board in the production of a product, (is), the production of the first side, on the tin is good, no problems at all. But the second plane production, refuse to welding in PCB, (such as the attachment). Through the analysis, because this is a question of PCB material, but the good side one tin, because what reason caused this?
    The answer:1. Limited by design, can only start production the first side (TOP), production after the second surface (BOT). Do with scrap PCB test, however, did not produce the first side of the board, directly print BOT surface tin, OK after furnace, and not the phenomenon of welding. Also ever changing different brands of solder paste, and repeatedly tried to adjust temperature. But bad product is more and less differences, unable to put an end to bad product.2. The problem of fruit out of furnace temperature setting and solder paste, the possible existence of the original ?
  • Previous:4.0 the PCB industry produced what challenges
    Next:Indonesia's 2014 tin exports fell to eight years in 2015 wil
  • Back
Address: NO.8,JINCANG ROAD. KECHENG,QUZHOU Tel: 86-570-8033868
Fax: 86-570-8033611 Email: pcb.cassie@ctpcb.com
Coptyright © 2015-2018 www.ctpcb.com All Rights Reserved. Quzhou Chuante Electronic Technology Co.,Ltd.